Tired of fighting the springs on your bolts? Struggling to hold the bolt while you remove the pins? This Bolt Tool is just what you need!
Designed to hold in ejectors to alleviate the spring pressure while you remove the ejector pin. When hit with a punch the ejector pin will fall into the cup underneath instead of rolling around on the floor. For reassembly, the screw holds the pin and spring back far enough for you to get the pin in without needing a 3rd hand.
If you need to work on extractors, you can do that, too. The AR base has its own slot for the extractor pin. On bolt action bases, (and depending on the design of your bolt), you can move the bolt forward and pivot it so that the extractor pin is vertical. Then tighten the screw to hold the bolt while you work!
Four screw sizes are available to accommodate different sizes of bolt faces. They are 223, Grendel, 308, and Magnum. All screws are interchangeable across all bases.
Please note: the 3-Lug base is designed around the Curtis Valor bolt which has a 0.750″ bolt body diameter. If you aren’t sure whether your 3-Lug action will work, please contact reese@thebulletpros.com.
Due to the wide number of combinations available, please message us at reese@thebulletpros.com if there is a combination you want that isn’t listed.
The pricing structure is as follows:
- Screws – $7.50 each
- Bases – $19.97 each
- Base with one Screw – $24.97
- Base with all Screws – $29.97
- Each additional base – $15
Coming soon: Winchester Model 70, Tikka T3
